Ford F150 2004+ Center Support Bearing Spacer Kit (SP001A0/1/2/3)

SP001A0 - Up to 4” Rear Lift - For use with JXB driveshaft carriers

• 2 female 2.5 mm bottom starter spacers

• 2 male 2.5 mm top finishing spacers

• 2 male/female 2.5 mm spacers

• 2 male/female 5 mm spacers

• 2 male/female 10 mm spacers

• 4 male/female 20 mm spacers

• 2 shorter 70 mm bolts

• 2 longer 100 mm bolts

• 2 bolt sleeves that allow installation with shoulder bolts that come with JXB driveshaft carriers

SP001A1 - 4-7” Rear Lift - For use with JXB driveshaft carriers

• 2 female 2.5 mm bottom starter spacers

• 2 male 2.5 mm top finishing spacers

• 2 male/female 2.5 mm spacers

• 2 male/female 5 mm spacers

• 2 male/female 10 mm spacers

• 8 male/female 20 mm spacers

• 2 shorter 130 mm bolts

• 2 longer 160 mm bolts

• 2 bolt sleeves that allow installation with shoulder bolts that come with JXB driveshaft carriers

Please note the SP001A0 and SP001A1 products can be purchased together with the JXB driveshaft carrier upgrade here using the dropdown box to add them.

SP001A2 - Up to 4” Rear Lift - For use with OEM center support bearings

• 2 female 2.5 mm bottom starter spacers

• 2 male 2.5 mm top finishing spacers

• 2 male/female 2.5 mm spacers

• 2 male/female 5 mm spacers

• 2 male/female 10 mm spacers

• 4 male/female 20 mm spacers

• 2 shorter 50 mm bolts

• 2 longer 80 mm bolts

SP001A3 - 4-7” Rear Lift - For use with OEM center support bearings

• 2 female 2.5 mm bottom starter spacers

• 2 male 2.5 mm top finishing spacers

• 2 male/female 2.5 mm spacers

• 2 male/female 5 mm spacers

• 2 male/female 10 mm spacers

• 8 male/female 20 mm spacers

• 2 shorter 110 mm bolts

• 2 longer 140 mm bolts

The exact steps to access the carrier will vary slightly by model, but the removal and installation of the new carrier are the same. The basic steps are:

• Remove any braces or splash shields preventing exhaust and heat shield removal

• Remove or lower exhaust in area of center support bearing if needed for access

• Remove heat shielding covering center support bearing

• If installing new carrier, Cut off OEM carrier and remove rubber support material with razorblade, leaving base layer of molded-on rubber intact on the bearing

• Clamp new carrier around OEM bearing

• Place CSB spacers on top of the carrier mounting tabs

• 2004+ Ford F150

SP001A0 - Up to 4” rear lift - for JXB driveshaft carriers
SP001A1 - 4-7” rear lift - for JXB driveshaft carriers
SP001A2 - Up to 4” Rear Lift - for OEM center support bearings
SP001A3 - 4-7” rear lift - for OEM center support bearings